Description
Fifteen purpose-built tools for servicing the SIG P220, P224, P225, P226, P227, P228, P229 and P239 frames and slides. Machined in our shop in NC.
Ships in a fitted case with an illustrated procedure guide. Instructional video.
What’s included
| 1 | Mainspring Seat Tool | Installing and removing the mainspring seat |
| 2 | Forceps | Holding the sear; setting the decocking lever spring |
| 3 | 3.5 mm Pin Holder | Stamped slides with outer and inner roll pins |
| 4 | Magnet Tool | Holding the decocking lever bearing captive |
| 5 | Sear Spring Tool | Loading the sear spring |
| 6 | Hammer | Driving punches and pins |
| 7 | 3 mm Long Punch | Aligning the sear stack; 3 mm slide pins |
| 8 | 3 mm Concave Punch | Domed pins |
| 9 | 3.5 mm Long Punch | Stamped slide pins and hammer pivot pins |
| 10 | 3 mm Half Round Punch | Long extractor slides |
| 11 | 3 mm Coil Pin Punch | Coil pins |
| 12 | 2 mm Long Punch | Hammer stop pin |
| 13 | 2 mm Starter Punch | Starting 2 mm pins |
| 14 | Needle Tool | Mag catch; aligning the hammer stop and spring |
| 15 | Slide Block | Supporting the slide during all pin work |
Plus: fitted case with numbered insert, and the illustrated procedure guide.
All punches and tools are available individually as replacements.
Reviews
There are no reviews yet.