Shims for Rail Cutter for 2011 Frames

Shims for Rail Cutter for 2011 Frames

1.00

For Limited 10 Frames- Limited 10 recommends cutting the rails slightly higher than a normal 1911, about .005 to .008
Here is the response Mosin received from Limited 10:
"2011 frames have a shorter deck height than a standard 1911. We try to keep ours at .445 to the middle of the slide stop
hole, minus a few more since we relieve the top of the frame so most slides will fit with a few thousandths clearance. This is
inline with every 2011 frame on the market (which measure about .340-.343 depending on brand//batch).
300-.320 is also a common depth for the feed ramp, depending on the builders philosophy. Many gunsmiths have the ramp
sit on the frame and use it as an impact surface, or with a small clearance, and many just hog it out. .300 allows the builder
to choose for a majority of barrels on the market."

Two shims included, a .003 and a .005. These shims put the frame up higher in the jig, thus the rails will sit higher, with the option of .003, .
005, or by using both- .008 higher as you so desire.
 

Quantity:
Add To Cart