Replacement Carbide Cutters For Rail Cutter- Choose Size

Replacement Carbide Cutters For Rail Cutter- Choose Size

30.00 40.00

Set of two cutters.

We have three thicknesses. Use .117 for cutting the rails on a 1911 or 2011- to get a tight slide fit if desired.

For slides from 1911builders.com, the .118 seems to work well.

The .119 thickness is specifically for cutting Sig rails. All cutters are interchangeable in all our rail cutting jigs.


Carbide Cutter Installation Instructions

The set screw than holds each carbide cutter was adjusted before shipping, and should not normally need adjustment. If there is any up and down movement, or if you are installing new cutters, carefully adjust the set screws located in the center of each cutter housing to keep the cutters pressed down onto the fixture to get an accurate cut. Cutters should not have any vertical play, but should still move back into housings when pushed in by hand (though with some effort) when the adjustment knobs are retracted. VERY IMPORTANT: If the set screws are too tight you will chip your carbide cutters on the retract stroke of the car. They cutters must be loose enough that you can push them with your fingers. Also, never reverse the screw when in the middle of a cut. That will also chip the cutters.


There is a good video illustration on cutter adjustment about 15 minutes in:

https://www.youtube.com/watch?v=Dvw64Y-tqms

Choose Size:
Quantity:
Add To Cart